SEN0240

SEN0240 is a Gravity analogue Electromyography(EMG) sensor cooperatively launched by DFRobot and OYMotion, and can reflect muscle and neural activities of human by detecting sEMG. This sensor integrates a filtering circuit and an amplified circuit. It amplifies minimal sEMG within ±1.5mV 1000 times and depresses noises (especially power frequency interference) by differential input and analogue filter circuit. The output signal is analogue which takes 1.5V as the reference voltage. The output voltage range is 0 to 3.0V. The signal strength depends on muscle activities. The output signal waveform indicates the muscle activity and helps to analyse and research the sEMG signals. Specifically, we can use Arduino as a controller to detect muscle activities, e.g. check whether the muscle is tense; the muscle strength; etc. This active induction sensor can provide high quality signal collection and it is easy to use.

• Metal dry electrode, long life, easy to use
• Differential input, high common mode rejection ratio
• Low power consumption, single power supply
• Supply voltage range from +3.3V to 5.5V
• ±1.5mV detection range, PJ-342 electrode connector
• PH2.0-3P module connector
• Operating temperature range from 0°C to 50°C
• Size is 22mm x 35mm (signal transmitter board), 22 x 35mm (dry electrode board)

목차

EMG dry electrode board x1, Wrist belt x1, Electrode cable x1, Emg signal transmitter board x1, Gravity analogue cable 3 pin x1.